CZ3D

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Find all posts by this user
11-02-2014, 12:23 AM
Post: #1
CZ3D
Quote this message in a reply
Need some help on how to hip mount a CZ3D. I thought there was a belt loop on the back side of the control box but was mistaken. Sure would appreciate any help.

Thank you.

Elbert
Find all posts by this user
11-02-2014, 01:19 AM
Post: #2
RE: CZ3D
Quote this message in a reply
You slide a belt through the mount that connects to the shaft Elbert

MichiganRelicHunter, proud to be a digger since 1977
Find all posts by this user
11-03-2014, 01:55 AM
Post: #3
RE: CZ3D
Quote this message in a reply
Thank you.

Elbert, proud to be a member of Treasure Classifieds Forum since Jun 2013.
Find all posts by this user
11-03-2014, 08:16 AM
Post: #4
RE: CZ3D
Quote this message in a reply
I made a chest mount for mine a while back that was very simple and a pleasure to hunt with. I used an old web military type equipment belt and sewed some shoulder straps on it and then used some 2" heavy duty velcro. Slip one side of the velcro through the slots in the back of the CZ3d mount and just stick it to you where you want in front. If you leave about a 3 or 4" tab on each side there's plenty of holding power to hold the box. At one time the mount that matches the one on the shaft was available with a belt loop but I have not seen one for a long time. An e-mail to Fisher might help you find one.

Dusty, proud to be a member of Treasure Classifieds Forum since Aug 2013.
Find all posts by this user
11-04-2014, 12:10 PM
Post: #5
RE: CZ3D
Quote this message in a reply
Thanks Dusty. Appreciate the info.

Elbert, proud to be a member of Treasure Classifieds Forum since Jun 2013.
Post Reply 




User(s) browsing this thread: 1 Guest(s)